No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form, or by any means, mechanical, electronic, photocopying, recording, or otherwise, without the prior written permission of OMRON.The CP Series is centered around the CP1H, CP1L, and CP1E CPU Units and is designed with the same basic architecture as the CS and CJ Series.
Mx2 Cp1 E Omron Modbus Manual For TheRefer to the appropriate manual for the information that is required.
This Manual CP1E CPU Unit Hardware CP1E CPU Unit Instructions CP1E CPU Unit Software Users Manual(Cat. Mx2 Cp1 E Omron Modbus Manuals As RequiredRefer to the appro- priate section in the manuals as required. CP1E CPU Unit Software Users Manual (Cat. No. W480) (This Manual) Section Contents. Section 3 Part Names and Functions This section describes the part names and functions of the CPU Unit, Expansion IO Units, and Expansion Units in a CP1E PLC. Fit the back of the Units onto the DIN Track by catching the top of the Units on the Track and then pressing in at the bottom of the Units, as shown below. DIN Track Press in all of the DIN Track mounting pins to securely lock the Units in place. Basic models of CPU Units are called E-type CPU Units in this manual. N-type CPU Unit An application model of CPU Unit that supports connections to Programmable Terminals, inverters, and servo drives. In no event shall the responsibility of OMRON for any act exceed the individual price of the product on which liability is asserted. This is not intended to be an exhaustive list of all possible uses of the products, nor is it intended to imply that the uses listed may be suitable for the products. It may represent the result of OMRONs test conditions, and the users must correlate it to actual application requirements. The safety precautions that are provided are extremely important to safety. Always read and heed the information provided in all safety precautions. Set the number of words of the DM Area to be backed up starting with D0 in the Number of CH of DM for backup Box in the Startup Data Read Area. Make sure that the external loads will not produce dangerous conditions when this occurs. Manual name Cat. No. Mx2 Cp1 E Omron Modbus Software Describes TheModel numbers Application Contents SYSMAC CP Series W480 CP1E-E To learn the software Describes the following information for CP1E CP1E CPU Unit Soft- specifications of the PLCs. Set the DIP switches on the Option Board and Expansion Units as required. Refer to Section 3 Part Names and Functions and Section 5 Installation and Wiring in the CP1E CPU Unit Hardware Users Manual (Cat. No. W479). The built-in RAM is used as execution memory and the built-in EEPROM is used as backup memory. CPU Unit. If the power is interrupted when the DM area is being backed up, the reading of backed up DM area will fail the next time power is turned ON.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |